2025-07-032025-07-032025-03-14OLIVEIRA, A. A. Efeito De Diferentes Agentes Cimentantes na Geração De Tensão, Deformação, Assentamento Vertical e Interface Adesiva em Facetas De Dissilicato de Lítio. 2025. 78 f. Tese (Doutorado em Odontologia) - Faculdade de Odontologia, Universidade Federal de Goiás, Goiânia, 2025.https://repositorio.bc.ufg.br/tede/handle/tede/14476Objetive: Evaluate the effect of luting lithium disilicate veneers with preheated resin composite on the shrinkage stress, strain, vertical seating, and luting interface compared to resin cement. Methods: Post-gel shrinkage, elastic modulus, compressive and diametral tensile strength of the NX3 light-cure resin cement (RC) and preheated Z100 resin composite (PHR) and were calculated to input into the 3D finite element analysis (FEA). Shrinkage stress/strain was analyzed using FEA. The shrinkage strain was analyzed by strain gauge measurements. vertical seating was measured in both groups. The t test was performed for the strain and Mann Whitney for the vertical seating. Results: Shrinkage stress was lower when cemented with NX3 than Z100 PHR. No statistical difference was found between the NX3 and Z100 PHR stain. No statistical difference was found between NX3 and Z100 PHR vertical seating measurements in the same stages. Cracks was found in SEM analysis in Z100 PHR luting interface. Significance: Veneers luted with RC showed lower stress. No difference was found between NX3 and Z100 PHR in the strain and vertical seating. Cracks formation was found in Z100 PHR.Acesso Embargadohttp://creativecommons.org/licenses/by-nc-nd/4.0/CimentaçãoResinas compostasCimentos dentáriosComposite resinResin cementFinite element analysisCIENCIAS DA SAUDE::ODONTOLOGIA::MATERIAIS ODONTOLOGICOSTese