Análise experimental de vigas de seção I compostas de perfis formados a frio com emendas soldadas, submetidas à flexão simples
Carregando...
Data
2010-03-19
Autores
Título da Revista
ISSN da Revista
Título de Volume
Editor
Universidade Federal de Goiás
Resumo
This paper presents an experimental study done in bi-metal beams supported from 3000 mm in length, composed of thin-walled, resulting in a section of the "I". The beams were formed from the welding of the souls of two metal profiles of type U. The variables were the type of profile used, the quantity and positioning of the welded seams. The beams were divided into two groups where the first group used profiles of the "U" and the second group used simple profiles such as "U" stiff. Each group was composed of three beams so that a beam does not receive any amendment, another amendment received a girder high up in the middle of the span, and the third top beam was amended so that the position would result in an amendment pierced. The applied load was set so as to leave the central part of the beams, which served as a region of the present study, working in pure bending. Test results for beams without amendment were compared with the theoretical results and served as a parameter to compare the behavior of these beams, with beams that were amended. Also a comparison was made between the bearing capacity of the two groups of beams. The experiments showed that, by making the proper control of welding there is no problem in making welded seams in the rafters. We also observed that the simple addition of stiffening beams tables promotes a significant increase in the bearing capacity. There was no correlation between failure modes provided theoretically and observed experimentally, thus, further studies are needed to properly analyze the theoretical results with experimental results.
Descrição
Palavras-chave
Citação
VIEIRA, Gregório Sandro. Experimental analysis of beams of the "I" made up of cold formed steel with welded seams, subjected to simple bending. 2010. 134 f. Dissertação (Mestrado em Engenharias) - Universidade Federal de Goiás, Goiânia, 2010.