EMC - Trabalhos de Conclusão de Curso
URI Permanente para esta coleção
Navegar
Navegando EMC - Trabalhos de Conclusão de Curso por Assunto "Abrasômetro"
Agora exibindo 1 - 1 de 1
Resultados por página
Opções de Ordenação
Item Projeto do sistema de controle de um abrasômetro pinolixa segundo a ASTM G132(Universidade Federal de Goiás, 2019-07-15) Couto, Bruno Ferreira; Katatani Junior, Sigeo; Katatani Junior, Sigeo; Fonseca, João Paulo da Silva; Gonçalves Júnior, José LúcioThis project aims to design a control system for an pin-on-disk tribometer that complies to the ASTM G-132 specifications. For this, a model wastested in scale to the control system of the abrasometer, with assistance of a Arduino Uno, a bridge drive H L298N and several permanent magnet direct cut motors. From the tests with the model, it was observed that the control by pulse width modulation to speed of rotation of direct corrente motors, done by drives of the H type, could not ensure the nominal torque when low frequencies of motor power signal switching were used; which must be compensated by the adequate selection of gear ratio of the motors. It’s also highlighted that after the construction of the abrasometer, it should be tested under known conditions, in order to validade the indications of frictional force and wear of the sample and ensure the reliability of the results obtained by it’s use.